Forum > Level Design

[Question] Changing the Stormwind model to the blank one

(1/2) > >>

Symi:
So, I managed to get it to save as the blank model in noggit but I can't seem to get it to transfer from noggit to a patch. When I log in game, Stormwind is still the same.


It -was- saving in noggit...and now it's back to being the other model of Stormwind. Frusterating! I can't get it to save again or turn into a patch. ._.

schlumpf:
Remove the model. Fly over all adts where it was on, save them. Do not use the "save all changed" feature, as it is broken and won't save all needed ones.

matija167:
I cant get schlumpf's tip working. the model keeps respawning each time i restart noggit, it even randomly spawns a few times while in the same noggit session.

I also tried replacing the Stormwind model with the goldshire inn model by duplicating the inn model and renaming it to stormwind.wmo. it is also not working, as i expected.

schlumpf:
It does not randomly spawn, but tiles you did not save are loaded, therefore loading the model as well.

Steff:
Clear themodel and then use the blure toll with an vary height circle. Click and have a look in the map (m) that all adts around stormwind plus2 ADTs rows around are marked whtie. The use save all.

Navigation

[0] Message Index

[#] Next page